|
Post by captsheetrock on Jun 23, 2007 13:24:40 GMT -5
Does anyone know if the roller flushers will roll and glaze a corner as well as a standard corner roller and angle head will? I have heard that they leave a hard edge and need to glazed by an angle head in order to acheive a clean corner, always looking for an easier way
|
|
|
Post by captsheetrock on Jul 12, 2007 14:52:00 GMT -5
thanks for the reply, I got a dvd with my set of alpha=tech's and they show one being run, but its not very well lighted and no close up, I'm always leery bout that, if its really as good why not show it in the light and give us a close up, I called them on the phone about it and they said that when they use it, they go right over it with the angle head to get the desired finish, so in their opion it is just another version of a corner roller. thanks again, and its good to see ya back again, I was beginning to think I was the only one left here..lol
|
|